V2 tins/lids

[halocog]

I just got my first order of V2 snus. Offroad frosted los and i also have some Odens classic los in the older can. Is it just me, or do these have a hard time sealing closed?

Also, I'm loving the Odens los. About to try the frosted. Updating my trading post, I'm not a fan of the Offroad frosted. Too coarse for me.

[Ansel]

V2 lids are cr@p.

[Nuusku]

The lids seem a bit small too

[mattarios]

yah the v2 lids are junk for sure. Just take a granit los lid and switch it onto your v2 can works like a charm, I do it on my thunder los cans.

[jagmanss]

yah the v2 lids are junk for sure. Just take a granit los lid and switch it onto your v2 can works like a charm, I do it on my thunder los cans.

IDK Man! I just tried fitting my granit los lid onto my thunder Frosted Los can and doesn't even come close to fitting... The granit los lid is waaaaaay too small.... I quess this is a case of YMMV.

[mattarios]

yea not sure, every granit can I have had the lid fits fine on my thunder los cans, it is a bit tight but fits for sure.

Do you have the new thunder cans/design or old?

Also the granit cans/lids I have been using are the old lids haven't tried it with the new granit lids yet.

[Chigger]

I usually have no issue with the V2 lids. That being said, lids are important. I recently ordered a roll of Thunder Original Los and was breaking up the roll to bag and freeze. The can at the bottom of the roll had no lid at all! That can went straight to the garbage because the snus did some really funky stuff to the label on the underside of the can above it. As much as I hate to throw out snus I knew I wouldn't enjoy the thought of using snus contaminated with label adhesive. I didn't bother trying to get it replaced, it obviously was not the fault of the place I ordered from.