This just might be a 'Captain Obvious" moment but since I haven't seen it said anywhere else I will go ahead:
I have made my $2 little prismaster 'adjustable' simply by sticking a little sewing pin (thats pin not needle) into its soft plastic on its slider face area so that its stopped before before it can slide all the way up (so I can have smaller pris without it accidentally sliding up higher/not having to depend on my having a firm grip to hold the slider in place while I play around with picking up the snus or if I decide to press & make it a firmer pris etc)
I have a pin hole where I formerly had it adjusted (that slot was a bit bigger than I wanted and have adjusted down)
I don't suppose the soft plastic of the prismaster will take a whole lot of being repeatedly re-poked either in the same hole or into new ones and I'm not sure how long even one poke hole if left alone will last before the plastic/hole becomes too soft to sustain the pin in a poked hole, but it works for me, for not anyway.
I stole this idea a bit from the 'make your own ice tool out of an oral syringe' idea (the part where you need to heat a pin and stick it at the top to keep the stopper from constantly popping out the end) but this didnt' even require heating the pin up. Super easy.
I have made my $2 little prismaster 'adjustable' simply by sticking a little sewing pin (thats pin not needle) into its soft plastic on its slider face area so that its stopped before before it can slide all the way up (so I can have smaller pris without it accidentally sliding up higher/not having to depend on my having a firm grip to hold the slider in place while I play around with picking up the snus or if I decide to press & make it a firmer pris etc)
I have a pin hole where I formerly had it adjusted (that slot was a bit bigger than I wanted and have adjusted down)
I don't suppose the soft plastic of the prismaster will take a whole lot of being repeatedly re-poked either in the same hole or into new ones and I'm not sure how long even one poke hole if left alone will last before the plastic/hole becomes too soft to sustain the pin in a poked hole, but it works for me, for not anyway.
I stole this idea a bit from the 'make your own ice tool out of an oral syringe' idea (the part where you need to heat a pin and stick it at the top to keep the stopper from constantly popping out the end) but this didnt' even require heating the pin up. Super easy.
Comment